Sideshifting Rear Only (Toward Streetside); Sideshifting Rear Only (Toward Curbside) - Landoll 380 Operator's Manual

Sideshifting Rear Only (Toward
Streetside)
NOTE
See Figure 3-6 for step drawings of what the trailer will
look like when shifting the entire trailer to the streetside.
Note that in this procedure only the rear will be
sideshifted.
1. The truck must be coupled to the trailer (trailer pivots
about kingpin), landing gear up, lift foot pads to clear
ground.
NOTE
Suspension lower switch should be in "ON" position.
2. Fully extend rear streetside outriggers and fully
retract rear curbside outriggers.
3. Set rear foot pads on ground and continue lifting rear
of trailer until undercarriage tires clear the ground
(approximately 1").
4. The rear of trailer can now be sideshifted to the
streetside. Insure that the trailer deck is level from
side to side.
NOTE
The ladder must be in stowed position.
a. Slowly raise the two rear outrigger control levers
(See Figure 3-3.) Feather the control levers to
allow the trailer to smoothly sideshift toward the
streetside.
b. For remote operation, push the side shift left
function on the rear section of the remote control
panel (See Figure 3-5.) Feather the buttons to
allow the trailer to smoothly sideshift toward the
streetside.
5. Before lowering trailer, release undercarriage brakes
(See Figure 3-3.) This allows the axles to roll back
under the trailer. Failure to release brakes will push
trailer forward when tires contact the ground.
6. After the trailer is on the ground, reset undercarriage
brakes (See Figure 3-3.)
For additional streetside sideshift movement, fully
7.
retract rear streetside outriggers and fully extend
rear curbside outriggers. Repeat
Sideshifting Rear Only (Toward
Curbside)
See Figure 3-6 for step drawings of what the trailer will
look like when shifting the entire trailer to the streetside.
Note that in this procedure only the rear will be
sideshifted and the outriggers will be moved in the
opposite direction from the drawing.
1. The truck must be coupled to the trailer (trailer pivots
Suspension lower switch should be in "ON" position.
2. Fully retract rear streetside outriggers and fully
3. Set rear foot pads on ground and continue lifting rear
4. The rear of trailer can now be sideshifted to the
The ladder must be in stowed position.
5. Before lowering trailer, release undercarriage brakes
6. After the trailer is on the ground, reset undercarriage
7.
steps 3 through 6.
OPERATING INSTRUCTIONS
NOTE
about kingpin), landing gear up, lift foot pads to clear
ground.
NOTE
extend rear curbside outriggers.
of trailer until undercarriage tires clear the ground
(approximately 1").
curbside. Insure that the trailer deck is level from side
to side.
NOTE
a. Slowly lower the two rear outrigger control levers
(See Figure 3-3.) Feather the control levers to
allow the trailer to smoothly sideshift toward the
curbside.
b. For remote operation, push the side shift right
function on the rear section of the remote control
panel (See Figure 3-5.) Feather the buttons to
allow the trailer to smoothly sideshift toward the
curbside.
(See Figure 3-3.) This allows the axles to roll back
under the trailer. Failure to release brakes will push
trailer forward when tires contact the ground.
brakes (See Figure 3-3.)
For additional curbside sideshift movement, fully
extend front and rear streetside outriggers and fully
retract front and rear curbside outriggers. Repeat
steps 3 through 6.
3-17