Shifting Trailer Forward Or Rearward; Pullout Strobe Beacon - Landoll 380 Operator's Manual

Shifting Trailer Forward or Rearward

1. With truck coupled to trailer and undercarriage (fully
rearward) in transport position, set trailer brakes and
release tractor brakes. Landing gear and lift leg
footpads to be up to clear ground.
2. Operate the axle control lever or remote button
"FORWARD" to pull the tractor and trailer backward
within short distance of loading dock or aircraft.
3. Lower landing gear, uncouple truck from trailer, set
all foot pads on ground, and continue lifting trailer to
match dock height.
4. After loading or unloading the trailer, lower the trailer
to the ground, and raise the lift leg footpads to be
clear of the ground.
5. Recouple the truck to the trailer and raise the landing
gear. Set trailer brakes and release tractor brakes.
6. Operate the axle control lever or remote button
"REARWARD" to push the tractor and trailer fully
forward to increase the distance to the loading dock
or aircraft. This will also put the undercarriage into
transport position.
SEE DETAIL A
FRONT BEACON
PULLOUT RELEASE
FRONT BEACON
PULLOUT RELEASE
DETAIL A
po-beacons
REAR BEACON PULLOUT
FULLY EXTENDED
Figure 3-8: Pullout Beacon Stored and Transport Position
OPERATING INSTRUCTIONS

Pullout Strobe Beacon

1. Pullout strobe beacons are located on the front and
rear of the trailer.
2. The pullout locks are released and the pullout slid the
designated distance and locked into place (See
Figure 3-8.)
3. Each pullout has six width options. Strobe beacon
lights and flag holders are located on the end of each
pullout.
NOTE
The pullout beacons should always be pulled out wider
than the load being transported.
REAR BEACON PULLOUT RELEASE
REAR BEACON
PULLOUT RELEASE
ACCESS
3-19