Table of Contents
Advertisement
CAN CONVERTER CABLE
TO COMMUNICATION
INTERFACE CABLE
interconnect cables
Remote Control ECM
Programming and Monitoring
The remote control functions can be checked using Plus
1 software monitoring package.
NOTE
Not all computer rear panel orientations are the same,
but the pin connections used are the same.
Getting Started Using Plus 1 Software
1. Install the Plus 1 programs from the CD provided (p/n
166909) in the order designated below:
a. PLUS 1 GUIDE 5.0.8 Service Tool
setup_Latest_1_C022245.exe
b. PLUS 1 GUIDE Service Tool 5.0.8 to 5.0.9
setup_Latest_1_C022482.exe
2. Install Kvaser and drivers:
a. kvaser_drivers_w2k_xp.exe
3. Once these files are installed, copy the following file
to your PC and double click to run. This will open the
Plus1 service tool with the application for your trailer.
a. A18475 Level Load Roller Trailer Diagnostic.P1D
4. The file listed below is a backup of the application
installed into the controller at the factory. This will
only be used in the event that the existing controller
must be replaced.
a. A18475 LEVEL LOAD ROLLER TRAILER.lhx
KVASER CABLE
Figure 4-23: Interconnect Cables
5. Attach Kvaser Cable/CAN Converter Cable
combination to the available USB port on your
computer and to the trailer near the controller (See
Figure 4-23.)
6. Start Plus 1 software only.
7. You are now ready to begin monitoring the remote
control system.
8. Follow the screens shots provided below to navigate
through the Plus 1 capabilities.
IMPORTANT
It is important to remember that before operating the
Plus 1 software, you must connect the software
"EACH TIME" by clicking on the "Connect" icon (See
Figure 4-24.)
tool bar partial
MAINTENANCE AND LUBRICATION
TO USB
PORT
"CONNECT" ICON
Figure 4-24: Connect Icon on Toolbar
4-31
Advertisement
Table of Contents
