Table of Contents
Advertisement
OPERATING INSTRUCTIONS
HANDRAIL LOCATED
OVER TOP OF
TRAILER DECK
LADDER IN POSITION TO USE
m160117 op
Preparing to Use the Ladder
1. Unpin ladder assembly and store pin back in hole
after ladder assembly is put in place for usage.
2. Pull ladder out from stored position. The top of the
ladder (closest to the front of trailer) will tilt up until
wheels touch the ground (closest to the rear of trailer
(See Figure 3-9.)
3. Pull up on handrail until it is in position.
4. Push the ladder back toward the trailer until handrail
stop is located over trailer deck leaving 3" between
ladder and siderail of trailer for pivot movement.
The ladder must be 3" from siderail of trailer and
stop over trailer deck before it is used. Failure to
do so may cause the ladder to fold up on the user
and may lead to serious personal injury.
3-20
LADDER SLIDES
AND PIVOTS
ON PIVOT ANCHOR
PULL GUARD RAIL UP
INTO PLACE
WHEELS
Figure 3-9: Steps for Ladder Usage and Storage
WARNING
IMPORTANT
The ladder must be in stowed position during
sideshift operations.
Storing the Ladder
1. Pull ladder back out releasing the handrail stop from
above the trailer deck (See Figure 3-9.)
2. Fold hand rail down into stored position against the
ladder.
Be careful not to pinch fingers when folding
handrail.
3. Pivot the ladder assembly to horizontal position.
4. Push ladder assembly under trailer deck and pin into
place.
PIN
LADDER IN
STORED POSITION
WARNING
F-618-0911 Edition
Advertisement
Table of Contents
