Towing The Semitrailer - Landoll 380 Operator's Manual

Level load roller trailer
Table of Contents

Advertisement

OPERATING INSTRUCTIONS

Towing the Semitrailer

Driving the towing vehicle with the semitrailer coupled
behind requires constant attention to the overall length of
the combination. The "hinged-in-the-middle"
configuration of the tractor and semitrailer, load, and
weight effect performance. Turning, passing,
acceleration, braking, stopping, and backup require
special considerations. When executing steep grades or
turning tight curves, the semitrailer must not be allowed
to push the towing vehicle, or jack knifing the semitrailer
with the towing vehicle may result. Application of the
semitrailer brakes to keep the semitrailer in tow will help
prevent this pushing. Braking should begin before
descending a hill or attempting a curve, to assure control.
When operating semitrailer, do not back over
curb. This will cause severe damage to
undercarriage.
3-6
CAUTION
1. Make a moving test of the semitrailer brakes at low,
and medium speeds before traveling at highway
speed.
a. The Anti-Lock Brake System (ABS) warning
lamp mounted at left rear side of the semitrailer
should come on when power is supplied to the
ABS by turning the tractor keyswitch on. The
warning lamp should go off once the semitrailer
exceeds 4 mph. If the warning lamp does not go
off, a fault exists in the semitrailer ABS. Once the
vehicle speed exceeds 4 mph, the light should
remain off unless a fault occurs or the keyswitch
is turned off, then on again.
If a fault exists in the semitrailer ABS, normal
braking will occur, but wheels may lock. Service
the ABS as soon as possible.
2. Monitor the air pressure gauge on the dash of the
towing vehicle. Pressure should not fall below 90 psi
at any time.
3. The semitrailer wheels track to the inside of the
towing vehicle during turns. Thus, turning corners
requires a wide swing to prevent "curb hopping", and
to allow the semitrailer wheels to clear any obstacle
on the inside of the corner.
4. To stop, use a gradual and smooth application of
brakes. If grabbing occurs, apply less pressure -
grabbing brakes are not efficient.
Always check behind and under the truck and
semitrailer for persons or objects before moving.
Failure to check can lead to serious personal
injury or death to others, or damage to property.
5. Backing should be done with care. Tail overhang,
semitrailer length, and allowable space must be
taken into consideration when backing the
semitrailer.
CAUTION
WARNING
F-618-0911 Edition

Advertisement

Table of Contents
loading

Table of Contents