Table of Contents
Advertisement
OPERATING INSTRUCTIONS
Sideshifting Front Only (Toward
Streetside)
NOTE
See Figure 3-6 for step drawings of what the trailer will
look like when shifting the entire trailer to the streetside.
Note that in this procedure only the front will be
sideshifted.
1. Lower landing gear, uncouple truck from trailer, and
lift foot pads to clear ground.
NOTE
Suspension lower switch should be in "ON" position.
2. Fully extend front streetside outriggers and fully
retract front curbside outriggers.
3. Set front foot pads on ground and continue lifting
front of trailer until landing gear clears the ground
(approximately 1").
4. Release undercarriage brakes (trailer pivots about
undercarriage tires) (See Figure 3-3.)
5. The front of trailer can now be sideshifted to the
streetside. Insure that the trailer deck is level from
side to side.
NOTE
The ladder must be in stowed position.
a. Slowly raise the two front outrigger control levers
(See Figure 3-3.) Feather the control levers to
allow the trailer to smoothly sideshift toward the
streetside.
b. For remote operation, push the side shift left
function on the front section of the remote control
panel (See Figure 3-5.) Feather the buttons to
allow the trailer to smoothly sideshift toward the
streetside.
6. Before lowering trailer, reset undercarriage brakes
(See Figure 3-3).
For additional front streetside sideshift movement,
7.
fully retract front streetside outriggers and fully
extend front curbside outriggers. Repeat
through 6.
3-18
Sideshifting Front Only (Toward
Curbside)
NOTE
See Figure 3-6 for step drawings of what the trailer will
look like when shifting the entire trailer to the streetside.
Note that in this procedure only the front will be
sideshifted and the outriggers will be moved in the
opposite direction from the drawing.
1. Lower landing gear, uncouple truck from trailer, and
lift foot pads to clear ground.
NOTE
Suspension lower switch should be in "ON" position.
2. Fully retract front streetside outriggers and fully
extend front curbside outriggers.
3. Set front foot pads on ground and continue lifting
front of trailer until landing gear clears the ground
(approximately 1").
4. Release undercarriage brakes (trailer pivots about
undercarriage tires) (See Figure 3-3.)
5. The front of trailer can now be sideshifted to the
curbside. Insure that the trailer deck is level from side
to side.
NOTE
The ladder must be in stowed position.
a. Slowly lower the two front outrigger control levers
(See Figure 3-3.) Feather the control levers to
allow the trailer to smoothly sideshift toward the
curbside.
b. For remote operation, push the side shift right
function on the front section of the remote control
panel (See Figure 3-5.) Feather the buttons to
allow the front of the trailer to smoothly sideshift
toward the curbside.
6. Before lowering trailer, reset undercarriage brakes
(See Figure 3-3.)
For additional front curbside sideshift movement,
7.
fully extend front streetside outriggers and fully
steps 3
retract front curbside outriggers. Repeat
through 6.
steps 3
F-618-0911 Edition
Advertisement
Table of Contents
