Shorthand Programming Mode - Avaya 2420 User Manual

2420 User Guide

Shorthand Programming Mode

1. Press Admin or
2. The function selection menu appears. The names down the right-hand side are the functions you
can select to assign to a key (except Expl?, see below).
• Pressing Expl?
Programming.
4. Use >>> and
5. When the function required is shown, press the
6. If the function requires some data to be entered, [ is shown at the bottom of the display. Enter the
data using the normal telephone keypad.
7. The upper part of the display reverts to showing the functions currently assigned to each
key.
8. Use the and
9. Select the display key against which to program the new function by pressing that
• Do not select the slot used for the Admin function. Replacing this function will lock the
phone for further programming until reset through the telephone system.
10. If the display slot is not already used, the display shows BUTTON PROGRAMMED!. Press the
or keys until EXIT is shown.
• Press
• Press Cont
11. If the display slot already has a programmed function, the display shows FEATURE ON
BUTTON. Press the
edge of the display.
• Press Repla
display then shows BUTTON PROGRAMMED! as above.
• Press Keep
• Press Delete
2420 User Guide
IP Office 3.0(DT)
Admin 1. See Display Key Programming.
switches to longhand programming mode, see Longhand
<<< to move through the list of functions.
keys to move between the pages of display keys.
EXIT to end programming.
to continue programming other functions.
or keys until Repla, Keep and Delet are shown along the right-hand
to replace that existing function with the one just programmed. The
to keep the existing function and forget the function just programmed.
to delete the existing function and forget the function just programmed.
key adjacent to its name.
40DHB0002USEG Issue 3d (16th March 2005)
and
or key.
Page 30