Procedures For Installing And Wiring Options On A Drive; Procedure A - YASKAWA MECHATROLINK-III Installation Manual

NOTICE
You can cause damage to the drive and connected equipment.
NOTICE
can cause the drive or option to function incorrectly.
NOTICE
can cause malfunction or damage to the equipment.
NOTICE
the drive and connecting peripheral devices. Incorrect connections can cause damage to the option.
◆

Procedures for Installing and Wiring Options on a Drive

Procedures to install and wire the option are different for different drivel models.
Refer to the following table to check the procedures to install and wire the option on a
drive.
Product Series
A1000
U1000
Z1000U
GA500
GA700
GA800
CR700
CH700
*1 To install the option on GA500 drives, use the option card mounting kit manual.
*2 Before you install the option on a YASKAWA AC Drive GA500, make sure that the option software version
is PRG: 6202 or later.
■

Procedure A

This section shows the procedure to install and wire the option on a 1000-series drive.
Prepare the Drive for the Option
Correctly wire the drive as specified by the manual packaged with the drive. Make sure
that the drive functions correctly. Refer to the following figure for an exploded view of
the drive with the option and related components for reference in the installation
procedure.
YASKAWA TOEP C730600 88A MECHATROLINK-III Installation Manual
Do not operate a drive or connected equipment that has damaged or missing parts.
Use Yaskawa connection cables or recommended cables only. Incorrect cables
Damage to Equipment. Correctly connect the connectors. Incorrect connections
Damage to Equipment. Make sure that all connections are correct after you install
Procedures for Installing and
Wiring Options on a Drive
Procedure A
Procedure A
Procedure A
*1 *2
Procedure B
Procedure B
Procedure B
Procedure B
5 Installation Procedure
Page
15
15
15
-
22
22
22
22
15