YASKAWA MECHATROLINK-III Installation Manual page 20

5 Installation Procedure
A - Option
B - Drive grounding terminal (FE)
Note:
The drive has only two ground terminal screw holes. When you connect three options, two options will
share one ground terminal.
5.
Select the proper MECHATROLINK-III dedicated communication cable according
to Table 5.1.
• You can route the option wiring through openings on the front cover of some
models. Remove the perforated tabs on the left side of the front cover as
shown in
• Route the option wiring inside the enclosure as shown in
proper precautions so that the front covers will easily fit back onto the drive.
Refer to the Peripheral Devices & Options section of the drive instruction manual
for more information.
Note:
Separate communication cables from main circuit wiring and other electrical lines to avoid potential
sources of electrical interference.
20
Figure 5.5 Connect the Ground Wire
Figure 5.6-A to create the necessary openings on these models.
YASKAWA TOEP C730600 88A MECHATROLINK-III Installation Manual
C - Ground wire
D - Included screws
Figure 5.6-B. Take