Connecting Jrr200 Route Reflector To Management Devices; Performing The Initial Configuration For Jrr200 - Juniper JRR200 Hardware Manual

JRR200 Route Reflector Hardware Guide

Connecting JRR200 Route Reflector to Management Devices

Performing the Initial Configuration for JRR200

48
To configure the JRR200 route reflector, you must connect a management device to the
CONSOLE port located on the front panel of the JRR200 route reflector, using the provided
RJ-45-to-DB-9 adapter and the RJ45 cable.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to the ESD point on the chassis.
Plug one end of the RJ-45 cable into the
2.
and the other end into the DB-9 serial port adapter.
Con sole port
RJ-4 5 cab le
Connect the DB-9 serial port adapter end of the RJ-45 cable to the serial port of your
3.
management device. Use the following values to configure the serial port:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—None
JRR200 Route Reflector Initial Configuration Using the CLI on page 49
JRR200 Route Reflector Factory-Default Settings on page 50
Viewing Factory-Default Settings of JRR200 Route Reflector on page 52
port of the JRR200 route reflector
CONSOLE
Serial port
Copyright © 2018, Juniper Networks, Inc.