Reflector; Table 21: Console Port Connector Pinout Information - Juniper JRR200 Hardware Manual

Console Port Connector Pinout Information for the JRR200 Route Reflector
Copyright © 2018, Juniper Networks, Inc.
The console port is an RS-232 serial interface that uses an RJ-45 connector to connect
to a console management device. The default baud rate for the console port is 9600
baud.
Table 21 on page 37 provides the pinout information for the RJ-45 console connector. An
Ethernet cable that has an RJ-45 connector at either end and an RJ-45 to DB-9 serial
port adapter are supplied with the route reflector.

Table 21: Console Port Connector Pinout Information

Pin Signal
1 RTS
2 DTR
3 TXD
4 Ground
5 Ground
6 RXD
7 DSR/DCD
8 CTS
Chapter 2: Site Planning, Preparation, and Specifications
Description
Request to Send
Data Terminal Ready
Transmit Data
Signal Ground
Signal Ground
Receive Data
Data Set Ready
Clear to Send
37