Installing The Jrr200 Route Reflector In A Rack; Table 22: Parts List For A Fully Configured Jrr200 Route Reflector - Juniper JRR200 Hardware Manual

Installing the JRR200 Route Reflector in a Rack

Copyright © 2018, Juniper Networks, Inc.

Table 22: Parts List for a Fully Configured JRR200 Route Reflector

Component
Route reflector
Power supply (pre-installed)
AC power cord appropriate for your geographical location (only for AC
models)
Rack mount kit
Quick Start installation instructions
Juniper Product ROHS and Warranty Document
End User License Agreement
Safety Guide
RJ-45 to DB-9 serial port adapter
RJ-45 cables
You can mount the route reflector on four posts in a 19-in. rack or cabinet by using the
rack-mount kit shipped with the device. (The remainder of this topic uses rack to mean
rack or cabinet.)
Before mounting the JRR200 route reflector on four posts in a rack:
Verify that the site meets the requirements described in
1.
for the JRR200 Route Reflector" on page
Place the rack or cabinet in its permanent location, allowing adequate clearance for
2.
airflow and maintenance, and secure it to the building structure.
Verify that the rack or cabinet meets the specific requirements described in
3.
Rack and Cabinet Requirements" on page
Remove the JRR200 route reflector from the shipping carton (see
4.
JRR200" on page 40).
Ensure that you have the following parts and tools available:
Electrostatic discharge (ESD) grounding strap
Screws to secure the mounting brackets to the chassis
Rack-mounting screws to secure the chassis to the four rack posts—not provided
Chapter 3: Initial Installation and Configuration
Quantity
1
2 AC or DC
2
1
1
1
1
1
1
2
"Site Preparation Checklist
29.
34.
"Unpacking the
"JRR200
41