Troubleshooting Hardware - Juniper JRR200 Hardware Manual

Table 23: Alarms for JRR200 Route Reflector Chassis Components (continued)
Component
Power supply
Copyright © 2018, Juniper Networks, Inc.
Alarm Conditions
A power supply has failed.
A power supply unit is not
present.
Power cord is not connected.
Power supply fan failure.
Input failure to the power
supply
Power supply drawing more
current than it should.
Unrecognized power supply
Power supply not powered
on.
Power supply internal devices
failure.
Chapter 5: Troubleshooting Hardware
Action
Replace the power supply.
Install a power supply unit in the
empty slot. JRR200 route reflector
requires two power supply units to
be installed.
Verify and ensure that the power
cord is connected properly.
As it is a non-recoverable fault,
replace the power supply.
Check the voltage of the power
source if it is in the operating
range.
Open a support case using the
Case Manager link at
https://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and
Canada) or 1-408-745-9500
(from outside the United States).
Open a support case using the Case
Manager link at
https://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and
Canada) or 1-408-745-9500 (from
outside the United States).
Open a support case using the Case
Manager link at
https://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and
Canada) or 1-408-745-9500 (from
outside the United States).
Connect the power supply to the
power source.
Replace the power supply.
Open a support case using the
Case Manager link at
https://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and
Canada) or 1-408-745-9500
(from outside the United States).
Alarm Severity
Steady red (major)
Yellow (minor)
Red (major)
Yellow (minor)
Red (major)
Red (major)
Red (major)
67