Table of Contents
Advertisement
JRR200 Route Reflector Hardware Guide
Unpacking the JRR200
Unpacking the JRR200 Route Reflector
Verifying Parts Received with the JRR200 Route Reflector
40
Unpacking the JRR200 Route Reflector on page 40
Verifying Parts Received with the JRR200 Route Reflector on page 40
The JRR200 Route Reflector is shipped in a cardboard carton, secured with foam packing
material. The carton also contains an accessory box and quick-start instructions.
CAUTION:
The JRR200 route reflector is maximally protected inside the
cardboard carton. Do not unpack it until you are ready to begin installation.
To unpack the JRR200 route reflector:
Move the cardboard carton to a staging area as close to the installation site as possible,
1.
where you have enough room to remove the components from the chassis.
Open the carton.
2.
Pull out the packing material holding the JRR200 route reflector in place.
3.
Verify the parts received against the inventory (packing list). The packing list specifies
4.
the part numbers and carries a brief description of each part in your order.
Save the shipping carton and packing materials in case you need to move or ship the
5.
JRR200 route reflector at a later time.
A packing list is included in each shipment. Check the parts in the shipment against the
items on the packing list. The packing list specifies the part numbers and descriptions of
each part in your order.
If any part on the packing list is missing, contact your customer service representative or
contact Juniper customer care from within the U.S. or Canada by telephone at
1-888-314-5822. For international-dial or direct-dial options in countries without toll-free
numbers, see
https://www.juniper.net/support/requesting-support.html
NOTE:
The parts shipped with your JRR200 route reflector can vary depending
on the configuration you ordered.
Table 22 on page 41
lists the parts and their quantities in the packing list.
.
Copyright © 2018, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
