Safety Messages - Emerson Rosemount 5600 Series Reference Manual

Reference Manual
00809-0100-4024, Rev CA
Section 1
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 9
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 10
Specific FCC requirements (USA only) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 12
Unpacking your Rosemount 5600 Transmitter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 14
Service support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 14
1.1

Safety messages

Procedures and instructions in this manual may require special precautions to ensure the safety of the
personnel performing the operations. Information that raises potential safety issues is indicated by a
warning symbol ( ). Refer to the safety messages listed at the beginning of each section before
performing an operation preceded by this symbol.
Explosions could result in death or serious injury:
Verify that the operating environment of the transmitter is consistent with the appropriate
hazardous locations certifications.
Before connecting a HART-based communicator in an explosive atmosphere, make sure the
instruments in the loop are installed in accordance with intrinsically safe or non-incendive field
wiring practices.
Failure to follow safe installation and servicing guidelines could result in death or serious injury:
Make sure only qualified personnel perform these procedures.
Use the equipment only as specified in this manual. Failure to do so may impair the protection
provided by the equipment.
Do not perform any service other than those contained in this manual unless you are qualified.
This product is an electrical apparatus and must be installed in the hazardous area in accordance
with the requirements of the EC Type Examination Certificate.
The installation and maintenance must be carried out in accordance with all appropriate
international, national and local standard codes of practice and site regulations for intrinsically safe
apparatus and in accordance with the instructions contained within this manual. Access to the
circuitry must not be made during operation.
Introduction
Introduction
Introduction
March 2020
9