Siemens SINUMERIK 840D sl Programming Manual page 586

Axis couplings
9.2 Curve tables (CTAB)
Significance
CTABDEL
<n>
<m>
<memory
location>
If CTABDEL is programmed without specification of the curve table to be deleted, then all
curve tables or all curve tables in the specified memory will be deleted:
CTABDEL ()
CTABDEL(,,"SRAM")
CTABDEL(,,"DRAM")
Note
If, in the case of multiple deletion with CTABDEL(<n>,<m>) or CTABDEL(), at least one of
the of the curve tables to be deleted is active in a coupling, the delete command will not be
executed; in other words, none of the addressed curve tables will be deleted.
586
Command for deleting curve tables
Number (ID) of the curve table to be deleted
When a curve table range CTABDEL(<n>,<m>) is deleted, <n> is
used to specify the number of the first curve table in the range.
When a curve table range CTABDEL(<n>,<m>) is deleted, <m> is
used to specify the number of the last curve table in the range.
<m> has to be greater than <n>.
Specification of memory location (optional)
In the case of deletion without a memory location being specified,
the specified curve tables are deleted in the static and the dynamic
NC memory.
In the case of deletion with a memory location being specified, of the
specified curve tables, only those located in the specified memory
location are deleted. The rest are retained.
"SRAM"
Deletion in the static NC memory
"DRAM"
Deletion in the dynamic NC memory
Deletes all curve tables in the static and the dynamic NC
memory
Deletes all curve tables in the static NC memory
Deletes all curve tables in the dynamic NC memory
Programming Manual, 06/2009, 6FC5398-2BP20-0BA0
Job Planning