Siemens SINUMERIK 840D sl Programming Manual page 590

Axis couplings
9.2 Curve tables (CTAB)
CTABMEMTYP
CTABPERIOD
<p>
<n>
<memory
location>
590
Returns the memory location of curve table number <n>:
0 Table in the static NC memory
1 Table in the dynamic NC memory
-1 Table does not exist
Returns the periodicity of curve table number <n>:
0 Table is not periodic
1 Table is periodic in the leading axis
2 Table is periodic in the leading and following axes
-1 Table does not exist
Entry number in memory
Number (ID) of curve table
Specification of memory location (optional)
"SRAM"
Static NC memory
"DRAM"
Dynamic NC memory
Note:
If a value is not programmed for this parameter, the default memory
location set with
MD20905 $MC_CTAB_DEFAULT_MEMORY_TYPE is used.
Programming Manual, 06/2009, 6FC5398-2BP20-0BA0
Job Planning