Advertisement
Step 8: Attach Roof Panels
Part 1
Note: Be sure to remove all plastic covering on both sides of the metal panels directly before installing
each piece.
A: Make sure panel is still square then on one Roof Panel Frame place one Side Panel flush to the top and sides
of the outside (831) Rafter on the side shown below. Panels should be flush to the top of the (837) Rafter Top.
There will be a slight overhang at the bottom. There are no holes on the ribs at the top of the panel. (F8.1, F8.2,
F8.3 and F8.4)
B: Place two more Main Panels beside the first then lastly one Side Panel so the panels overlap and screw holes
line up as shown below. (F8.1 and F8.5)
C: Attach all four Panels to Roof Panel Frame using nine #8 x 1" Hex Roofing Screws in locations shown in F8.1.
Do not install screws to the bottom (839) Strap Short and (840) Strap Long. Be sure not to overtighten screws.
D: Repeat Steps A - C for the second Roof Panel Frame.
F8.1
Side Panel
Start on
this end
(831) Rafter
(839) Strap Short
DO NOT overtighten
screws, could cause
damage to roofing
material
F8.5
#8 x 1" Hex
Roofing
Side View
Screws
Panel
Panels overlap
at the seams
Roof Panel Set:
4 x Main Panel
4 x Side Panel
Main
Panel
Bottom
F8.3
Slight
overhang
Panel
(840) Strap
Long
Panel
(831) Rafter
Y01033-274 - Main Panel x 4
25
#8 x 1" Hex
Roofing Screws x 9
Top
Side Panel
(831) Rafter
Panel
132-1/2"
3.37 m
F8.4
Hardware
Y01033-273 - Side Panel x 4
R0-Roo ng Scr. #8 x 1 (48)
18 x #8 x 1" Hex Roofing Screw
(837) Rafter
Top
F8.2
Side View
Flush
(837) Rafter
Top
support@yardistrystructures.com
Advertisement
