Advertisement
Step 5: Frame Assembly and Anchoring
Part 1
A: Move your Post Assemblies to the final location. Make sure the ground is flat and level before continuing
assembly.
B: With one person at each Post stand two complete Post Assemblies. A third person places one Side Beam
Assembly against the outside of each Post, flush to the tops and outside corners. Notice bolt hole orientation
on the assemblies. A fourth person attaches Beam to Post with one 3/8 x 8-1/2" Hex Bolt (with two 3/8" large
washers and one 3/8" lock nut) in the top hole, per Post. The distance from the outside of one Post to the outside
of the second Post should be 9' 6-1/2" (2.91 m). (F5.1, F5.2 and F5.3)
C: Place one Gable Beam Assembly against two Post Assemblies so the (832) Gable Inside faces the inside and
is flush to the top and outside corner of Side Beam Assembly, then attach with one 3/8 x 7-1/4" Hex Bolt (with two
3/8" large washers and one 3/8" lock nut) in the bottom hole, per Post. The distance from the outside of one Post
to the outside of the second Post should be 9' 1" (2.77 m). (F5.1 and F5.2) See F5.3 for accurate positioning of
Posts.
Side Beam
Assembly
F5.1
Gable Beam
Assembly
Post
Assembly
Plinth
F5.3
9' 6-1/2"
(2.91m)
Post to Post
post to post
10'-6"
1
9'-4
" 2
plinth to plinth
Gable Beam
Assembly
(832) Gable
Inside
Post
Assembly
Note hole
orientation (on
bottom)
8' 8"
(2.64 m)
Post to Post
11' 7-1/8"
(3.53 m)
Post to Post
7' 7-1/2"
(2.32 m)
Plinth to Plinth
Avery Inst 4 - Frame Assem
Side Beam
Assembly
Post
Assembly
Gable Beam
Assembly
8' 6"
(2.59 m)
Plinth to Plinth
3/8 x 7-1/4"
Hex Bolt
4 x 3/8 x 8-1/2" Hex Bolt (3/8" large washer x 2, 3/8" lock nut)
4 x 3/8 x 7-1/4" Hex Bolt (3/8" large washer x 2, 3/8" lock nut)
17
x 3
D: Repeat Steps B and C for remaining
Beam Assemblies. See F5.3 for accurate
positioning of Posts.
F5.2
3/8" Large
3/8" Lock
Washer
Nut
Post Assembly
Hardware
support@yardistrystructures.com
Side Beam
Assembly
3/8" Large
Washer
Flush
3/8 x 8-1/2"
Hex Bolt
Advertisement
