Advertisement
Step 7: Roof Panel Frame
Part 2
D: Lay out three more (831) Rafters beside the first three, then tight to each (839) Strap Short place one (840)
Strap Long and tight to the first (840) Strap Long place one (839) Strap Short. Make sure the wider gap on each
strap is on the outside. Make sure the assembly is square, pre-drill the first (840) Strap Long with a 1/8" drill bit,
as shown below, then attach (840) Strap Longs and (839) Strap Short with 24 #8 x 1-3/4" Wood Screws. The
screws where the straps meet are inserted at an angle. (F7.3 and F7.5)
E: Tight to the first (837) Rafter Top attach a second (837) Rafter Top with six #8 x 2-1/4" Wood Screws. (F7.4
and F7.5)
F7.5
Y50000-840 - Strap Long
Y50000-839 -Strap Short
Y50000-837 -Rafter Top
F7.3
Side View
(839) Strap
Short
Notice large
notch gap on
outside ends
Wood Parts
2 x (839) Strap Short
4 x (840) Strap Long
2 x (837) Rafter Top
Avery Inst 6A - Frame Roof Panel
(837)
#8 x 1-3/4"
Rafter Top
Wood Screws
(x 24)
Bottom
Notice
screws at
an angle
Notice small notch
gap on inside ends
where straps meet
(840) Strap Long
(pre-drill pilot holes
for this board only)
F7.4
(831)
Rafter
(840) Strap
Long
Notice large
notch gap on
outside ends
48 x #8 x 1-3/4" Wood Screw
12 x #8 x 2-1/4" Wood Screw
21
(840) Strap
Long
(839) Strap
Short
(831) Rafter
(837)
Rafter Top
Flush
S15-Wood Screw #8 x 1-3/4,
#8 x 2-1/4"
Wood Screws
(x 8)
Hardware
support@yardistrystructures.com
Advertisement
