Advertisement
Step 2: Post Assemblies
A: At the bottom of each (752) Post insert two 5/16" T-Nuts as shown in F2.1 and F2.2.
B: At the bottom of each (752) Post place two Post Mounts tight to the bottom and inside faces as shown in F2.1
and F2.2. Loosely attach with one 5/16 x 1-1/4" Hex Bolt (with 5/16" lock washer and 1/4-5/16" large washer) per
mount so they connect to the T-Nuts.
C: On each side of the Posts, place one (738) Plinth flush to the bottom and attach with four #8 x 1-3/4" Wood
Screws per plinth. Rounded edges on top. (F2.1 and F2.3)
D: From the bottom of each Post Mount attach to posts with two #8 x 1-3/4" Wood Screws per mount and then from
the inside with two #10 x 1-1/4" Pan Screws per mount These screws are installed at a slight angle. Tighten all
bolts. There will be four Post Assemblies. (F2.4)
F2.1
Top
Bottom
#8 x 1-3/4,
st Mount Set
Wood Parts
4 x (752) Post
16 x (738) Plinth
(752)
Post
Post
Mount
5/16 x 1-1/4"
Hex Bolt
5/16" Lock
Washer
(752)
Post
F2.4
Post
Mount
#10 x 1-1/4" Pan Screws (x 2
per Post Mount, from inside)
F2.2
Rounded
Edge on Top
5/16" T-Nut (x 2
per Post)
Post
Mount
1/4 - 5/16"
Large Washer
16 x #10 x 1-1/4" Pan Screw
80 x #8 x 1-3/4" Wood Screw
8 x Post Mount
13
F2.3
(738) Plinth
(752)
Post
Post
Mount
#8 x 1-3/4" Wood Screws
(x 2 per Post Mount, from
bottom)
Hardware
8 x 5/16" T-Nut
8 x 5/16 x 1-1/4" Hex Bolt
(with 5/16" lock washer, 1/4-5/16" large washer)
support@yardistrystructures.com
(752)
Post
#8 x 1-3/4"
Wood Screws
(x 4 per Plinth)
Advertisement
