Advertisement
Step 3: Gable Beam Assembly
A: Place two (833) Gable Beams tight together, then place one (846) Gable Upright Assembly centred, on one side
of (833) Gable Beams and one (832) Gable Inside on the other side. (832) Gable Inside to be flush to top of (833)
Gable Beams. Loosely attach (846) Gable Upright Assembly to (833) Gable Beams and (832) Gable Inside with
one 5/16 x 3" Hex Bolt (with 5/16" lock washer, 1/4-5/16" large washer and 5/16" t-nut) in the top hole and 5/16 x
2" Hex Bolt (with 5/16" lock washer, 1/4-5/16" large washer and 5/16" t-nut) in the bottom hole. Note: Bolt holes to
the bottom of each (833) Gable Beam. (F3.1 and F3.2)
B: Attach (832) Gable Inside to (833) Gable Beams with six #8 x 1-3/4" Wood Screws. Tighten bolts from Step A.
(F3.1 and F3.2)
C: Place one (848) Gable End tight to each side of (832) Gable Inside, flush to the top of (833) Gable Beams then
attach with three #8 x 1-3/4" Wood Screws per board. (F3.1 and F3.2)
D: Repeat Steps A - C one more time to make a second Gable Beam Assembly.
(846) Gable
Upright
Assembly
F3.1
Front
5/16"
T-nut
(832) Gable
Inside
(848) Gable End
(833) Gable
Beam
Wood Parts
4 x (833) Gable Beam
2 x (846) Gable Upright Assembly
2 x (832) Gable Inside
4 x (848) Gable End
(848) Gable End
5/16" Lock
Washer
1/4 - 5/16"
Large Washer
Flush and
Tight
Flush
(848) Gable End
(833) Gable
Beam
Notice holes
on bottom of
both boards
5/16 x 3"
Hex Bolt
5/16 x 2"
Hex Bolt
(832) Gable
Inside
5/16 x 3 - Y07718-330, 5/16 x 2 -Y07718-320
#8 x 3" Wood Screw Y06091-530
Y50000-833 -Gable Beam, Y50000-832 -Gable Inside
Y50000-848 - Gable End
2 x 5/16 x 2" Hex Bolt
(5/16" lock washer, 1/4-5/16" large washer, 5/16" t-nut)
2 x 5/16 x 3" Hex Bolt
(5/16" lock washer, 1/4-5/16" large washer, 5/16" t-nut)
24 x #8 x 1-3/4" Wood Screw
14
Notice the
direction the
bolts are being
installed.
(846) Gable
Upright
Assembly
Notice bolt
Flush
hole on top of
board
#8 x 1-3/4"
Wood Screw
x 12
Hardware
support@yardistrystructures.com
F3.2
Back
(833) Gable
Beam
(848) Gable End
Advertisement
