6.7. Power cables, ground cables, equipotential
bonding conductor
See "Appendix A - Additional manuals" for information on:
–
Project-specific cable entry
–
Distance between point of cable entry and terminals
–
Busbar and fastening hole dimensions
–
Installation instructions for sealing modules
See "Appendix D - Wiring diagrams" for information on:
–
Designation, cross-reference and device identification conventions
–
Transformer cables and motor cables and their corresponding connections
6.7.1. Preparing the cable entry and the cables
NOTICE
Waste inside the cabinet can cause damage or malfunction.
–
If possible, do not cut cables inside the terminal compartment.
–
Retrieve any waste which accidentally dropped into the cabinet.
6.7.1.1. Determining the cable length
1. Determine the required length of a cable between the point of entry and the
connection point inside the cabinet.
2. Cut the cable to the required length before connection.
PRODUCT
ACS5000W
Risk of damage or malfunction!
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS799208 E01
ELECTRICAL INSTALLATION
REV.
LANG.
PAGE
F
en
99/178