Periodic Inspection - Panasonic YP-060PF Operating Instructions Manual

12 Maintenance (continue)

12.2 Periodic inspection

Touching any current-carrying parts may cause a fatal electric shock or burn injury
To secure physical safety, make sure that a qualified person or a person who is
familiar with the cutting machine takes care of a regular check.
· As for the inside check, make sure to conduct it at least 5 minutes after turning the
power off in consideration of electric discharge from a capacitor.
·After removing machine case, please do the necessary protection around the
Please
When abnormity happens during the inspection, please do not repair by yourselves.
For the details of after-sales service of the Product, please refer to the charpter of "Warranty and after-sales
service".
Attention
About cleaning of plastic parts
Plastic parts may be melted or deformed when they are subjected to organic solvent (benzin, toluene, kerosene,
Gasoline, etc.). When cleaning them, soak a soft cloth with a small amount of water or diluted mild detergent for
home use, and wring it and use for wiping those parts.
·Daily checks are not enough to keep the proper performance of this product for a long time. Perform the periodic
check without fail. It is important to keep the proper performance of this product for a long time.
· In the periodic check, after cutting off power source check the product thoroughly including checking and cleaning
of the inside of this product.
· Except the cleanness of water filter, conduct the periodic check every 6 months normally. If there is a mass of fine
dust, oily smoke, etc. Around this product, perform the regular check every month as a guideline).
· Please record the executed date of the inspection and cleanness on the data plate (Fig. 1) on the right side of the
power source.
Please periodically
machine.(year/month/date)
(For detailed inspection contents, please refer to the operational manual of the product.)
Periodic spot
check executing
date
machine, preventing other people from accessing the Machine incidentally.
(every 3 ～ 6 months)
execute
1
/ /
4
/ /
WARNING
inspection and
2
/ /
5
/ /
56
cleanness inside the
3
/ /
6
/ /
cutting