Operation Area - Panasonic YP-060PF Operating Instructions Manual

6 Names and Functions (continuous)

6.4 Operation area

12
Reference :
7-segment numeric display and round indicator in this Chapter are named LED in short.
·There may be differences between the displayed setting current value on the digital display window
①
( ) and the actual output value. It's not guaranteed that the cutting condition current value and
other measured data are being used as the management data of measuring device. (Please take
them as the use of reference target.).
·The output display shows the average value.
① Digital display window
• The digital ammeter
The average current is displayed in the unit of 1A.
When the cutting time is relative short, in consideration of the data sampling speed, there may be some
differences compared with the setting value.
•The setting value display
The setting values of display current and time etc, corresponding indicator
according to display contents,.
In case of abnormal situation happens, it is displayed 【 Error number 】
②The unit indicator
The corresponding unit indicator LED of the value on digital display is lit.
•「A」 current unit
For items related setting current, it is lit
During cutting, it blinks.
•「mm」 length unit
By using cutting navigation, it is lit during the setting cutting the thickness.
By using cutting result to display the distance between the cutting tip and base metal, it is lit.
•「Mpa」 pressure unit
During air check, it is lit.
By using cutting navigation, when air pressure is displayed, it is lit at the moment of displaying
recommended condition after condition setting finishes,.
•「m/min」 speed unit
By using cutting navigation, when cutting speed is displayed, it is lit at the moment of displaying
recommended condition after condition setting finishes,.
Note:
Expect above-mentioned unit, unit display LED is not lit.
(During the cutting torch monitoring time setting and cutting torch cable length selection, the unit display
LED is not lit.)
1
8
9
10
Please pay attention to the use of displayed data
2
3 5
15
4 6
②
(LED) start to change
7
11
-over,