The Cutting Torch Monitoring Function - Panasonic YP-060PF Operating Instructions Manual

8 Settings and Operations (continue)
No. Setting Setting items
Cutting torch
P10 cable length 10,20,30
select
35,60,80 ， 100
Cutting torch
35P,60P,80P ，
P11
select
100P
LoC （ operation
Setting for
lock ）
P12 operation lock
PCH （ password
* 3
modification ）
Pulse cutting (oFF)
P13
setting * 4 (on)
no
P14 All reset
yes
※1 For gouging selection function, please refer to 【8.7 gouging function 】
※2 For the cutting torch monitoring function, please refer to 【8.6the cutting torch monitoring function 】
※3The data listed here are used for 100PF. For 80pfthe cutting torch, setting option of 35, 60 and 80 are
available and the initial value is 80. For 60PF the cutting torch, setting option 35, 60, initial value 60.
※4 For the setting of the lock key, please refer to 【8.9 operation lock function 】
※5 For pulse cutting setting, please refer to 【10.5.3 pulse cutting 】

8.6 The cutting torch monitoring function

· To prevent the cutting torch from reducing cutting capacity and burning loss caused by the overuse of
electrode and cutting tip, pre-warning function can be selected.
·The monitoring of arc ignition number of times and actual cutting time is achievable. When one of
them reaches set warning value, warning contents can be displayed.
·It can be selected on the submenu either stop the output of the machine or just display warning
information when machine detects that the usage of the electrode and cutting tip reaches service life.
Set unit Default
Select the length of the cable to be used.
By using the selection on the cable length and cutting torch , the recommended
m 10
gas pressure can be automaticaly changed according to the specifications of
the cutting torch.
35, 60, 80 and 100 represents curved cutting torch, 35P, 60P, 80P and 100P
straight handled cutting torch.
For connection with robot cutting, please select straight handled cutting torch.
If select curved cutting torch was selected, signal from robot would not be
received.
A 100P If the ratings of selected cutting torch are within the rated specification of the
cutting machine, set upper limit value of current can be limited within the rated
specification of the selected cutting torch.
In addition, recommend gas pressure of the selected cutting torch can be
automaticaly changed according to the specifications, cutting torch cable
length.
The operations such as the modification on the cutting current setting value and
the value of submenu etc. can be locked. It can be enabled or disabled by using
— — password.
Duirng the lock operation, operation lock LED on operation area is lit.
The password being set before shipment is " 123 ".
When pulse cutting ( P13 ) is set on " ( ON ) " status , pulse cutting function
is enabled.
— OFF
When the gouging selection ( P01 ) is " ( ON ) " , even if pulse cutting ( P13 )
is set on " ( ON ) " status, this function is not valid.
When cutting condition and setting contents on submenu are to be restored to
factory settings, this function can be used.
— no
After selecting ( yes ) , press confirmation button, untill ( off ) is displayed. Then
it is required to restart the power source.
28
Descriptions