The Treatment After Operation; Discharge The Condensate Water From The; Cutting Torch; Turn Off Power Switch - Panasonic YP-060PF Operating Instructions Manual

11 The treatment after operation

11.1 Discharge the condensate water from the cutting torch
The condensate water the water transformed from the moisture content in the cutting air.
Please do not operate the cutting torch switch at random.
·air can blow from cutting tip end and high voltage can be generated from the
cutting tip of the cutting torch, causing fatal electric shock and burn.
Please
Regarding the anti-freezing of the cutting torch
·When the ambient temperature is lower than lower than 0℃ in winter and cold regions, if the cutting
torch is handled improperly after cutting, condensate water remained in the cutting torch may be frozen.
·After discharging condensate water in the cutting torch, storage the cutting torch in the place where
the torch can be frozen.
·If condensate water in the cutting torch is frozen, air cannot flow from the cutting tip end. So please
use the torch after melting the frozen condensate water and discharging the water.
The operation of removing condensate water
(1) Be sure that the cutting torch end does not point to the operator or other people.
(2) On stand-by status, press the DECIDE button (air check).
(3) When air spray from the cutting torch end, please confirm whether or not the condensate water flows
out.
·If there is condensate water flowing out, please press air check button several times until all
condensate water drains away.
Note
※ The air filter of the Machine is set on automatic water draining mode.
※When there is no pressure in the air filter, condensate water in the drain valve can automatically
discharge. (drain valve is connected with flexible hose and located at left rear side of the Machine。 The
water may flow onto the floor. If the clean and tidy of the floor is affected, please clear it.)
Note
In case the remaining condensate water in the cutting torch cannot discharge from the air filter
automatically. (Please refer to condensate water discharging operation written on the page and
discharge the condensate water.)

11.2 Turn off power switch

After the operation finishes, please turn off power switch.
WARNING
53