Connection; The Connection Of Output Cable - Panasonic YP-060PF Operating Instructions Manual

7 Connection

Observe the following cautions to prevent electrical shocks. Touching an
electrically charged section can cause a serious electrical shock or burn.
· Before installing or performing maintenance/inspection work, turn off all the input
power supplies at the distribution box; and overhaul at least 5 minutes after turning
off the switch box. After the safe working condition is confirmed, restart the
operation.
· Tighten the connection at joint sections of the cables, and insulate those sections
properly.
· After operation, please be sure to restore and install the removed cover and panel
etc.
Please correctly use protective gear, including protection gloves, safety shoes and long sleeve
clothes etc., to protect yourself from human injury, arc flash, flying spatter, slugs and noise
generated during the use of the cutting power source.
·This equipment and instructions are for use only by persons trained and experienced in the safety
operation of cutting equipment. Do not allow untrained persons to install, operate, or maintain this
equipment. Or consult with sales distributor and ask the service distributor to execute the operation.
·The wiring and grounding should be done by educated and/or skilled person.
·To insure the safe operation, please connect the input side after the connection of the output side.
·Please use the cable with specified sectional area or bigger.
· Please fasten the cable connection firmly.

7.1 The connection of output cable

（1） output terminal （-）
side
（ 2 ） the cutting torch
switch socket
(1) The output terminal (-) side: connect the cutting torch.
(2) The cutting torch switch socket: connect the plug of the cutting torch switch.
(3) The pilot arc terminal: connect the pilot arc terminal of the cutting torch.
(4) The output terminal (+) side: connect base metal cable.
Note:
For the base metal cable, please use cable with specified sectional area or bigger.
WARNING
CAUTION
17
（4） output terminal （+）
side
（3） pilot arc terminal