The Confirmation On Air - Panasonic YP-060PF Operating Instructions Manual

9 Operation methods (continue)
(4) For electrode, cutting tip, please use specialized hand tool in accessory of the cutting torch to fasten them
firmly.
(5) Please use hand to fasten the protection cover of the cutting torch.
Note:
· When you use pliers or wrench and use too much strength, the cutting torch may be damaged.
· The insufficient fastening may activate the safety circuit, causing the machine stopping cutting.
※
For details, please refer to the operational manual of the cutting torch.

9.4 The confirmation on air

Plasma arc exposure against a body part such as hand or finger may cause a burn.
·During cutting, do not touch cutting tip and electrode of the cutting torch end.
·During confirmation, please do not press the cutting torch switch.
To confirm air, please execute according to the below mentioned sequence.
(1) Turn on the distribution box.
(2) Turn on the power switch
(3) press confirmation (air check) button.
(4) Confirm air blowing from cutting tip end of the cutting torch.
Note:
Except air, if water outflows, please keep air check at ON status, please release all water.
(5) Rotate air pressure adjusting knob, until the recommended range air pressure LED is lit.
Note:
During the adjustment of the air regulator, it is required to pull up the touch rotary knob lock of the air regulator
rotary knob. After the adjustment finishes, press rotary knob to execute rotating lock.
(6) After the air confirmation and air pressure adjustment, press 「DECIDE」 (air check) button to end the air check.
Even if「DECIDE」 〔 air check 〕 button is not pressed, air check finishes after 60s.
WARNING
38