The Power Switch; The Output Terminal Area - Panasonic YP-060PF Operating Instructions Manual

6 Names and Functions (continuous)

6. 2 The power switch

Before starting the generator, please cut off power switch.
•The power source ON/OFF change-over on the machine outer case.
After turning on power switch, LED on the operation area is lit and software version number is displayed,
then cooling fan starts to rotate, finally machine runs into stand-by status. This process takes about 6
seconds. During this period, all switches, key, knob, expect the power switch, are not functional. If the
cutting torch switch is pressed, machine transfers to stand-by status 【The cutting torch switch display
abnormal 「E07」 】.
•Notice:
When the generator is used, please be sure to turn off the power switch of the machine before starting
the generator.
•The procedure of cooling fan
The cooling fan starts to rotate after turning on the power switch
Cooling fan stops to save energy and machine runs into energy saving state 7 minutes after the cutting
machine remains in stand-by state.
Once cutting operation restarts, the cooling fan rotates again.

6. 3 The output terminal area

Regarding connection and disconnection of the cable, to avoid electric shock and
malfunction, please be sure to cut off the switch of distribution box and then start the
operation.
(1) output terminal
(-)side
(2)the cutting
torch switch socket
(1)Output terminal (-) side: connect the cutting torch.
(2)The cutting torch switch socket: connect the cutting the plug of the torch switch.
(3)The pilot arc terminal: connect pilot arc terminal of the cutting torch.
(4)The output terminal (+) side: connect base metal cable.
WARNING
Front
WARNING
14
Power switch
(4)output terminal
(+)side
(3)pilot arc terminal