Panasonic YP-060PF Operating Instructions Manual page 6

2 Important Safety Items (continuous)
Installing shielding (curtain etc.)
Arc flash, flying spatter, slugs, and
noise generated during cutting can
damage your eyes, skin and hearing.
(1)Install a protective curtain around the cutting
manipulator site to prevent the arc flash from
entering the eyes of people in the surrounding area.
(2)When cutting or monitoring cutting, wear safety
glasses with sufficient light blocking structure or
use a protective mask designed for cutting
operation.
(3)When cutting or monitoring cutting wear protective
clothing designed for cutting operation, such as
leather gloves, leg cover and leather apron, and also
wear long-sleeve shirts.
(4)Be sure to wear noise-proof protective equipment if
the noise level is high.
(5)The larger the cutting current is, or in case of AC
TIG or MIXTIG cutting, the larger the AC frequency
is, the larger the arc sound becomes.
Gas cylinder and gas flow regulator
Overturn of gas cylinder and blowout
of gas flow regulator can cause injury.
(1)The gas cylinder must be handled properly according
to the applicable law and in-house standards.
(2)Use the gas flow regulator that is supplied or recom-
mended by our company.
(3)Read the instruction manual of the gas regulator prior
to using it, and observe the cautions in the manual.
(4)Secure the gas cylinder to a dedicated gas cylinder
stand.
(5)Do not expose the gas cylinder to high temperature.
(6)When opening the valve of the gas cylinder, do not
bring your face close to the discharge outlet.
(7)When the gas cylinder is not used, be sure to install a
protective cap.
(8)Do not hang the cutting torch on the gas cylinder, or
touch the gas cylinder with the electrode.
(9)Do not attempt to disassemble or repair the gas
regulator. Such works require special knowledge.
Rotating parts
Rotating parts can cause injury.
(1)Keep away from rotating parts such as cooling fans，
and feed roller of the wire feeder, or hand, finger(s)，
hair or part of your clothes may be caught by the
parts resulting in injury.
(2)Keep all covers, panels and cases closed when
using the product.
(3)Maintenance work and repair should be perform only
by educated and/or skilled persons who thoroughly
understand cutting machines. While
CAUTION
performing maintenance work or repair work, provide
fence or the like around the cutting machine so that
unauthorized person can not come close carelessly.
Cutting wire
Cutting wire, especially wire tip part can
cause injury.
(1)Do not perform inching operation or pull the torch
switch with your eyes, face or body close to the end
of the cutting torch - wire extends out from the end
of the cutting torch and may stick into the eye, face
or body.
(2)In case of using a torch cable with the resin liner,
straighten the torch cable and reduce the preset
feed amount (current) to a half or less before
applying the wire inching.
(3)Performing wire inching while torch cable has been
bent extremely can cause the wire to pierce the
resin liner and cable. Make sure to replace any
damaged liner or cable with a new one, or damaged
liner/wire can cause
degradation.
. Against insulation deterioration
Insulation deterioration can cause fire of
cutting power source.
(1)Keep enough distance from cutting power source
when performing cutting or grinding work so as to
prevent spatters or iron particles from getting
into the power source.
(2)Perform check and maintenance work periodically
so as to prevent insulation deterioration due to
accumulated dust or dirt.
(3)When spatters or iron particles get into the cutting
power source, turn off the power switches of the
cutting power source and power distribution box,
and then blow out.
(4)Make sure to replace any damaged liner or cable
with a new one as use of damaged liner/cable may
cause gas leak or dielectric degradation.
(5)In order to avoid dust and dirt to be collected inside
of the power source, make sure not to leave the
panel and bolts (including eyebolts) open and
removed.
2
gas leak or dielectric