Cooper Lighting WaveLinx Lite User And Programming Manual page 39

User Manual: WaveLinx Lite (1.5)
Select the site
Note: To make it easier to find in the mobile app, the occupancy set can be renamed by tapping on the pencil icon '
6: In the 'Settings' screen, review the settings or tap on the pencil icon ' 'in any section to edit the behavior. Refer to the chart for information
on the items shown.
Select the area
Setting Default
Current Status N/A
Mode Occupancy
Not connected
Connected
Verify network
connection
Tap 'Occupancy'
Description
Displays the current status of the occupancy set, either
occupied or unoccupied.
Note: Status reflected does include the hold time delay and will only
revert to unoccupied once hold-time expires.
Tap edit '
occupancy or vacancy mode.
• Occupancy mode: The defined occupied level will occur
when any sensor in the group detects initial motion.
• Vacancy mode: The sensors will not perform any action
upon initial motion detection. The occupant must turn ON
loads manually using controls in the space. WARNING: Do
not use vacancy mode unless WaveLinx Lite Wallstations
are installed in the system to allow for manual override.
For both modes, the lighting will start transitioning to the
unoccupied level when motion is not detected by all sensors in
the occupancy set after the defined hold time period expires
Select the occupancy
set to modify
'at the top of the settings screen.
' in the 'Mode and Hold Time' section to select
www.cooperlighting.com 39