Delete A Zone - Cooper Lighting WaveLinx Lite User And Programming Manual

6: In the list of devices in the zone, locate the device to move. If needed, use the identify icon '
found.
7: Tap the minus icon ' '.
8: When prompted, select the zone to move the device to. The display will show several informational messages and then return to the zone
details view once the move is complete.
If needed, use 'identify' to
locate the correct device

Delete a Zone

IMPORTANT: Although a zone with devices will allow the devices to be moved when the zone is deleted,
communications issues may occur if multiple devices are in the zone. For best results, move the devices out of the
zone before deleting the zone. See the instructions starting on page 31 for information on moving devices.
To delete a zone:
1: Bring the mobile device within range (within 60 feet) of any provisioned WaveLinx Lite device in the desired area.
2: Ensure that the mobile device Bluetooth is turned on, and then open the WaveLinx Lite Mobile Application.
3: In the site list, select a site.
4: In the area list, select the desired area. After a short delay, verify that the area shows that the mobile application is connected to the network.
Tap on the icon if it is necessary to refresh the connection.
5: In the zone list, select the zone. Make sure there are no devices in the zone being deleted. If needed, follow the procedures on page 31 to
move the devices before proceeding.
6: Tap on the delete icon '
Select the site
32 www.cooperlighting.com
Select the destination
zone for the device
Tap the '-' to
move the device
' and then confirm by tapping 'Delete'.
Select the zone
Select the area
' to flash the loads until the correct one is
Not connected
Connected
Verify network
connection
Select the delete icon
User Manual: WaveLinx Lite (1.5)
Tap 'Delete'