Cooper Lighting WaveLinx Lite User And Programming Manual page 12

Line Voltage Wallstation (continued)
12 www.cooperlighting.com
Identification Mode Behavior
When placed in 'Blink to Identify' mode, the wallstation LED will turn ON for 1 second, turn OFF
for 1 second and repeats this cycle for 15 seconds. The LED will be green on an unprovisioned
wallstation and white on a provisioned wallstation.
Factory Reset Instructions
The factory reset will unprovision the device, setting the device back to factory settings. The
device will revert back to out-of-the-box behavior and will need to provisioned and
reprogrammed.
Factory
reset button
Loss of Communications Operation
There is no special operation for loss of communications for the wallstation. When the
wallstation is powered, it will send a command anytime a programmed button is pressed. If the
controlled devices receive the signal, they will respond.
Operation upon Return of Power
The wallstation does not have any special behavior on powerup. Once powered, the wallstation
will wait for the button to be pressed before sending any commands.
Remove the wallplate to expose the factory reset
•
button.
• Press and hold the factory reset button for 5-10
seconds and then release it. (The wallstation LED will
begin to flash yellow (1 sec. ON, 1 sec. OFF) after 5
seconds and stop at 10 seconds.
After a short period of time, the device should exhibit
•
out-of-the-box behavior and may be provisioned again.
User Manual: WaveLinx Lite (1.5)