Adjust Individual Occupancy Sensor Settings - Cooper Lighting WaveLinx Lite User And Programming Manual

User Manual: WaveLinx Lite (1.5)
6: In the 'Settings' screen, review the settings or tap on the pencil icon ' ' at the top of the screen and type a unique name for the occupancy
set. Tap 'Save'.
Tap edit

Adjust Individual Occupancy Sensor Settings

While most sensor settings will be assigned in the occupancy set, specific settings are available at the individual sensor level in the 'Device
Details' page.
To access the device's occupancy sensor details page:
1: Bring the mobile device within range (within 60 feet) of any provisioned WaveLinx Lite device in the desired area.
2: Ensure that the mobile device Bluetooth is turned on, and then open the WaveLinx Lite Mobile Application.
3: In the site list, select a site.
4: In the area list, select the desired area. After a short delay, verify that the area shows that the mobile application is connected to the network.
Tap on the icon if it is necessary to refresh the connection.
5: In the zone list, select the zone where the fixture mounted occupancy sensor resides.
6: In the list of devices in the zone, locate the device. If needed, use the identify icon '
Select the site
Select
the area
Enter desired name
Tap 'save'
Select the zone
' to flash the loads until the correct one is found.
Verify network
connection
Not connected
Connected
If needed, use 'identify' to
locate the correct device
Tap device to open the
'Device Details'
www.cooperlighting.com 37