Air Spring Installation - Silver - SRAM Rockshox Judy Series Service Manual

2 0 0 H o u r S e r v i c e
Inspect each part for scratches. Do not scratch any sealing surfaces when
servicing your suspension. Scratches can cause leaks.
When replacing seals and o-rings, use your fingers or a pick to remove the
seal or o-ring. Spray isopropyl alcohol on each part and clean with a clean
lint-free shop towel.
Apply Liquid-O-Ring PM600 or SRAM Butter grease to the new seals and
o-rings. If a brush is used to apply grease, confirm there are no loose
bristles in the grease or on the part.
1 Apply grease to the air shaft.
Install the top out bumper, All-Travel spacer (A) if originally equipped or
added if travel is reduced, and the negative air assembly onto the air
shaft.
2 Apply grease to the inside of one end of the air tube, approximately
60 mm into the tube.
A i r S p r i n g I n s t a l l a t i o n - S i l v e r
NOTI CE
PM600
A

Air Spring Installation - Silver

SRAM Butter
52