50 Hour Service - SRAM Rockshox Judy Series Service Manual

4 Place an oil pan beneath the fork to catch the draining oil.
Loosen both bottom bolts 3 to 4 turns.
5
Insert a 5 mm hex wrench into each bottom bolt head and strike the
wrench to dislodge the shafts from the lower leg. The bolt head should
contact the bottom of the lower leg.
Remove each bottom bolt. Clean each bolt and set them aside.
6 Firmly pull the lower leg downward until oil begins to drain. Continue
pulling downward to remove the lower leg.
If the lower leg does not slide off of the upper tube or if oil does not
drain from either side, the press fit of the shaft(s) into the lower leg may
still be engaged. Reinstall the bottom bolts 2 to 3 turns and repeat the
previous step.
Do not strike the fork arch with any tool when removing the lower
leg as this could damage the lower leg.

50 Hour Service

Continue the 50 Hour Service with
200 Hour Service Continue the 200 Hour Service with
NOTI CE
Lower Leg
Lower Leg Seal
5 mm
5 mm and Mallet
5 mm and Mallet
Service.
Service.
5 mm Damper side
Spring side
Spring side
Damper side
Lower Leg Removal
Spring side
Damper side
26