Use your fingers to remove the bumper cone from the air shaft.
11
Install a new bumper cone onto the air shaft so it covers the
tension pin hole.
N O T I C E
If the pin tension is protruding or not centered, replace the piston
assembly.
S O L O A I R S P R I N G I N S T A L L A T I O N
Apply a liberal amount of grease to the inside of the upper tube,
1
from the end of the tube to approximately 60 mm into the tube.
Apply a liberal amount of grease to the air piston.
2
Apply a liberal amount of grease 40-60 mm around the air shaft.
3
Install the floating seal head, a new floating seal head topout
bumper, new aluminum support washer, new wavy washer and the
air shaft guide, in that order, onto the air shaft.
13
SOLO AIR SPRING INSTALLATION