Air Spring Installation - SRAM PIKE RCT3 Service Manual

2 0 0 H o u r S e r v i c e
It is optional to change maximum fork travel by replacing the stock air spring shaft assembly with a shorter or longer air spring shaft assembly. If
maximum travel is increased or reduced, use the new complete air spring shaft assembly in the following installation steps. It may also be necessary
to add or remove Bottomless Tokens™. Refer to
Refer to the RockShox® Spare Parts Catalog available at
contact your local SRAM® distributor or dealer.
Apply a liberal amount of grease to the inside of the upper tube, from
1
the end of the tube to approximately 60 mm into the tube.
Apply a liberal amount of grease to the air spring shaft.
2
Apply grease to the new seal head inner o-ring and wiper seal.
3
A i r S p r i n g I n s t a l l a t i o n
Air Spring Travel Change and Bottomless Tokens
www.sram.com/service
for details.
for the required spare part kits. For part ordering information, please
DebonAir™
DebonAir
Dual Position Air™
Dual Position Air
26

Air Spring Installation