50 Hour Service - SRAM RockShox SEKTOR Service Manual

Insert a 5 mm hex wrench into the bolt head and strike the wrench to
5
dislodge the shafts from the lower leg on each. The bolt head should
contact the bottom of the lower leg.
Remove each bottom bolt. Clean each bolt and set them aside.
Firmly pull the lower leg downward until fluid begins to drain. Continue
6
pulling downward to remove the lower leg.
If the lower leg does not slide off of the upper tube or if oil does not
drain from either side, the press fit of the shaft(s) into the lower leg may
still be engaged. Reinstall the bottom bolts 2 to 3 turns and repeat the
previous step.
Do not strike the fork arch with any tool when removing the lower leg
as this could damage the lower leg.

50 Hour Service

Continue the 50 Hour Service with
200 Hour Service Continue the 200 Hour Service with
NOTI CE
Lower Leg
Lower Leg Seal
5 mm & Mallet
5 mm & Mallet
Service.
Service.
Spring side
Damper side
Lower Leg Removal
Spring side
Damper side
12