Fitting A Component - Festo CPVSC1-VI Manual

5. Maintenance and conversion
5.3.3

Fitting a component

5−8
Fig. 5/2: Removing a component in a valve location
Please note
The valve plate and work sub−base is a unit tested for
leakage by Festo.
Do not disconnect the screw connectors in the work
sub−base.
They guarantee that the unit does not leak.
Proceed as follows:
1. Make sure that the seals are correctly seated between the
components on the valve terminal. They must lie correctly
in the appropriate seal grooves.
Festo P.BE−CPVSC−EN en 0301a