Aapts (Ambient Air Pressure And Temperature Sensor) Installation; M6 X 20 Hexagonal Flange Screw; Storage Compartment); M6 X 12 Hexagonal Flange Screw - BRP Can-Am Spyder RS 2011 Series Predelivery Bulletin

rbl2011-002-006_a
1. Horn harness
2. AAPTS (Ambient Air Pressure and Temperature Sensor) harness
3. Front storage compartment cover cable
4. DLC (Diagnostic link cable connector)
CE Models — Countries with Left-Hand Traffic
6. Before installing storage compartment, replace
the low beam lights. Refer to
LIGHT (CE MODELS)
All Models
7. Assisted by another person, position front stor-
age compartment into support slots of vehicle.
Ensure that all cables are accessible prior
NOTE:
to installing front storage compartment.
8. Secure the front storage compartment.
– On TOP, use four M6 x 20 hexagonal flange
screws
– At the bottom, use two M6 x 12 hexagonal
flange screws.
rbl2008-003-212_a
TOP SCREWS
1. M6 X 20 hexagonal flange screws
PREDELIVERY
LOW BEAM
.
rbl2008-003-213_b
BOTTOM SCREWS
1. M6 X 12 hexagonal flange screws
Install all screws before tightening them.
NOTE:
FRONT STORAGE
COMPARTMENT
SCREW
M6 X 20 hexagonal
flange screw
M6 X 12 hexagonal
flange screw
AAPTS (Ambient Air Pressure
and Temperature Sensor)
Installation
1. Add foam provided in the PDI kit to protect the
tip of the AAPTS.
2. Secure it using M6 X 20 hexagonal flange screw
and M6 caged nut (included in the PDI kit).
rbl2008-003-211_a
AAPTS SENSOR INSTALLATION

1. M6 X 20 hexagonal flange screw

2. M6 caged nut
3. Foam
3. Route cable through retaining guide clips.
2011-1
PARTS TO BE INSTALLED
TORQUE
4.5 N•m (40 lbf•in)
10 N•m (89 lbf•in)
9 / 32