Hang Tag And Safety Labels - BRP Can-Am Spyder RS 2011 Series Predelivery Bulletin

rbl2008-003-215_c
1. Retaining screws
3. Pull out headlight.
4. Repeat the procedure for the remaining head-
light.
5. Discard the removed headlights. Keep the
screws for installation.
6. Install the new headlight into position.
The left-hand traffic headlights can be rec-
NOTE:
ognized by the number 10895 on the lens rim (the
right-hand traffic ones have the number 10894).
rbl2009-001-009_a
1. Number 10895 for left-hand traffic headlights
7. Secure headlight with the original screws.
8. Torque screws to 11 N•m (97 lbf•in).
9. Set the adjusting screws to the same length as
noted on the original headlights.
PREDELIVERY
rbl2009-001-006_a
1. Adjustment screws
10. Repeat the procedure for the remaining head-
light.
All CE Models
1. Connect wiring harness to low beam head-
lights.
rbl2008-003-215_b
1. Low beam headlight connector
2. Verify low beam headlights aiming. Refer to
LIGHTS ADJUSTMENTS
in

Hang Tag and Safety Labels

This vehicle comes with a hang tag and labels
containing important safety information. The
labels are considered permanent parts of the
vehicle and should not be removed. Hang tag is
to be removed by the owner only.
Any person who rides this vehicle should read and
understand all the information given on hang tag
and safety labels before riding.
Safety labels of several language can be chosen
by customer, according to availability.
2011-1
PARTS TO BE INSTALLED
.
13 / 32