Rear Fender; Low Beam Light (Ce Models) - BRP Can-Am Spyder RS 2011 Series Predelivery Bulletin

PARTS TO BE INSTALLED
rbl2011-002-013_a
1. Cable grommet
2. Harness bracket
5. Connect fender light connector.
rbl2011-002-014_a
1. Fender light connector
6. Secure fender support on wheel hub.
6.1 Install the harness bracket over the fender
support and secure them on wheel hub us-
ing a M8 x 35 hexagonal flange screw and
a sleeve from the PDI kit.
rbl2011-002-015_a
1. M8 x 35 hexagonal flange screws
2. Sleeves (one hidden)
3. Harness bracket
6.2 Install 3 other M8x 35 hexagonal flange
screws and sleeves to complete the
fender support installation.
FENDER SUPPORT RETAINING SCREW
24 N•m (18 lbf•ft)
12 / 32
7. Carry out the same procedure for the other
side.

Rear Fender

1. Remove packaging from rear fender.
2. Connect brake light connector.
3. Secure brake light harness inside the RH rear
fender support using 3 locking ties (from PDI
kit).
Three locking tie retainers have been in-
NOTE:
stalled at factory to hold locking ties.
4. Install rear fender on vehicle using M6 X 20 Torx
screws, plastic washers and M6 elastic flange
nuts (included in PDI kit).
REAR FENDER SCREW
7 N•m (62 lbf•in)
5. Verify if brake light harness touches to rear tire.
Reposition harness if required.

Low Beam Light (CE Models)

Countries with Left-Hand Traffic
The low-beam headlights must be changed for
left-hand traffic countries to ensure proper low
beam aiming.
1. Note the position of the adjustment screws on
the installed headlight.
rbl2009-001-006_a
1. Adjustment screws
2. Remove retaining screws from headlight.
2011-1 PREDELIVERY