rbl2008-003-100_d
FRONT PANELS PLASTIC RIVETS LOCATION
Upper Side Panels
1. Install plastic washers on M6 x 20 Torx screws
(included in the PDI kit).
2. Install upper side panels as the reverse of the
removal procedure.
LH Rear Panel
Ensure that LH rear panel is reinstalled on vehicle.
Service Cover
Install service cover on the front of vehicle (in-
cluded in front service compartment).
ADJUSTMENTS
Guidelines
All adjustments have already been performed
at factory. It is only necessary to validate them.
However, if readjustment is needed, refer to the
appropriate
ROADSTER SHOP MANUAL
proper procedure.
Drive Belt
NOTICE
Always verify drive belt tension with
all parts at room temperature and the rear
wheel lifted of the ground.
1. Place vehicle on a level surface.
The area must be protected against wind
NOTE:
and must have a very low background noise.
2. Set transmission to NEUTRAL.
3. Lift rear of vehicle by the frame until rear wheel
is off the ground.
NOTICE
Do not lift under rear shock absorber.
Always lift by the frame. Refer to illustration.
PREDELIVERY
rmr2008-030-009
TYPICAL - LIFT BY THE FRAME
4. To check the drive belt tension use the
TENSION METER (P/N 529 036 115)
529036115
5. Enter the following specifications to program
the meter.
MASS
8.4 g/m
for the
rmr2008-031-002
SONIC TENSION METER DISPLAY
Refer to the manufacturer's instructions to
NOTE:
set the informations into the device.
6. Turn rear wheel to align a wheel spoke with the
swing arm.
2011-1
ADJUSTMENTS
.
WIDTH
SPAN
28.0 mm/R
1028 mm
BELT
19 / 32