Front Fenders; Locking Tie (Rear Fender) - BRP Can-Am Spyder RS 2011 Series Predelivery Bulletin

rbl2010-002-029_a
1. Installation side
2. Install two M6 panel nuts (from PDI kit) on each
fender.
rbl2011-002-009_a
1. Panel nuts
3. Position mudguards on proper fender.
4. Secure mudguards using M6 x 20 Torx screws
(from PDI kit).
MUDGUARD SCREW TIGHTENING TORQUE
3 N•m (27 lbf•in)

Front Fenders

1. Cut locking tie that hold harness bracket on
fender.
PREDELIVERY
rbl2011-002-010_a
1. Locking tie
2. Position front fender on vehicle.
rbl2011-002-011
3. Route front brake hose on fender hook.
rbl2011-002-012_a
1. Brake hose
2. Fender hook
4. Properly insert cable grommet on harness
bracket.
2011-1
PARTS TO BE INSTALLED
11 / 32