Vehicle Cleaning; Delivery To Customer - BRP Can-Am Spyder RS 2011 Series Predelivery Bulletin

9.4 Shift in neutral position, slightly apply on
throttle then release.
10. Reverse interlock operation (SM5 Model).
10.1 With the engine running attempt to shift
into reverse without pulling the reverse
interlock lever back.
10.2 Release the clutch lever.
10.3 If the transmission is allowed to shift to
reverse, the reverse interlock will need to
be adjusted.
11. Throttle operation.
– The throttle is the right handgrip, and it
controls engine speed. To increase engine
speed, roll the throttle toward you. To de-
crease engine speed, roll the throttle away
from you. The throttle is spring loaded and
should return to idle when you release it.
11.1 With handlebars turned fully left and then
fully right, ensure that the throttle returns
completely to idle position.
12. Clutch lever operation (SM5 Model).
– The clutch lever is in front of the left hand-
grip. The clutch controls the transmission
of power from the engine to the rear wheel.
The lever is squeezed to disengage power
and released to engage power.
13. Engine stop switch operation.
– The engine stop switch is near the right
handgrip. It has two positions and must be
set to the run position before you can start
the engine. It allows you to stop the engine
anytime without removing your hand from
the handlebar.
14. Operation of the following lights:
– Headlights
– Taillights
– Brake light
– Position lights
– Turn signals
– Hazard lights
– Licence plate light.
15. Dimmer switch operation.
16. Headlight overrun button operation.
– There is a headlight override button on the
front of the right handgrip.
17. Horn operation.
– The horn button is located near the left
handgrip.
18. Leakage of the following fluids:
– Fuel
PREDELIVERY
– Engine oil
– Engine coolant
– Brake fluid
– Clutch fluid

Vehicle Cleaning

NOTICE Do not clean the windshield with al-
kaline or acid cleaner, gasoline or solvent to
avoid windshield damage.
NOTICE Never use a high pressure washer to
clean the vehicle. USE LOW PRESSURE ONLY
(like a garden hose). The high pressure can
cause electrical or mechanical damage.
NOTICE
It is necessary to use flannel cloths on
plastic parts to avoid damaging surfaces.
NOTICE Do not wash the seat with a vinyl or
plastic cleaner because the seat may become
slippery.
NOTICE Certain plastic or vinyl cleaners will
damage the seat cover. Use only mild deter-
gent, such as soap specially formulated for mo-
torcycles or automobiles.
1. Wet the vehicle thoroughly with water.
2. Wash the vehicle with water mixed with a mild
detergent, such as soap specially formulated
for motorcycles or automobiles.
3. Dry the vehicle with a chamois or a soft towel.
While washing the vehicle, check for
NOTE:
grease or oil. If necessary, use a mild automotive
degreaser and follow the manufacturer's instruc-
tions.

Delivery to Customer

PREDELIVERY CHECK LIST
Complete the
The customer and dealer must read and sign the
PREDELIVERY CHECK LIST
2011-1
FINAL INSPECTION
.
.
27 / 32