Licence Plate Installation; Accessories Installation; Vehicle Decals; Fluids - BRP Can-Am Spyder RS 2011 Series Predelivery Bulletin

FLUIDS

rmo2008-001-102

Licence Plate Installation

When a license plate needs to be installed
NOTE:
or replaced, ensure to install two new damping
pads (P/N 293 740 028) on plate to be installed.
1. Remove existing plate on vehicle (if applicable).
2. Peal off backing of new damping pads.
rmo2008-002-509_a
1. Damping pad backing
3. Position new damping pads over existing pads
on vehicle plate support.
rmo2008-002-510_a
1. Damping pads
4. Secure upper portion of license plate on vehicle
plate support using existing hardware.
14 / 32
5. Squeeze license plate and support together at
each lower corner.

Accessories Installation

1. Install accessories (if any) as per their installa-
tion instructions (included in each kit).
2. Install any other equipment required by law (if
any).

Vehicle Decals

1. Install decals on vehicle according to customer
country language and local legislation.
2. Ensure that the new decals are installed at the
same location and over the factory installed de-
cals.
FLUIDS

General Guidelines

All fluids (except fuel) have already been filled
at factory, it is only necessary to validate them.
However, if refill is needed, refer to the appropri-
ROADSTER SHOP MANUAL
ate
procedure.

Fuel

1. Add a small amount of fuel in the fuel reservoir.
rmo2008-001-016
FUEL RESERVOIR
Recommended Fuel
Use unleaded gasoline or oxygenated fuel con-
taining no more than 10% ethanol or methanol or
both. The gasoline used must have the following
minimum octane rating:
MINIMUM OCTANE RATING
North America
Outside North America
2011-1
for the proper
87 (R+M)/2)
92 RON
PREDELIVERY