Wheel Installation; Tires Pressure; Parts To Be Installed; Battery - BRP Can-Am Spyder RS 2011 Series Predelivery Bulletin

PARTS TO BE INSTALLED

4. Clean rear brake disc using
PARTS CLEANER (P/N 219 701 705)
rag.
NOTICE A thin layer of anticorrosion treat-
ment is present on the brake disc and must be
removed before using the vehicle. Not con-
forming to this procedure may lead to a brake
chattering squeaking and brake pad replace-
ment would be necessary.
5. Apply parking brake.
6. Lift the front of vehicle.
7. Remove front wheels and clean brake discs us-
ing
XPS BRAKES AND PARTS CLEANER (P/N 219
and a clean rag.
701 705)

Wheel Installation

1. Install front wheels on vehicle.
2. Ensure that the rotation direction shown by the
arrow is respected.
WARNING
The tires are only designed to rotate in one di-
rection. Do not switch the left and right front
wheels.
3. Tighten wheels lug nuts by hand.
4. Lower vehicle.
5. Torque wheels lug nuts.
WHEEL LUG NUT TIGHTENING TORQUE
105 N•m (77 lbf•ft)
6. Install wheel caps (located inside front storage
compartment).

Tires Pressure

WARNING
Low pressure may cause tire to deflate and
rotate on wheel. Overpressure may burst the
tire. Always follow recommended pressure.
NOTICE Always check pressure when tires are
cold before using the vehicle.
Tire pressure changes with temperature
NOTE:
and altitude. Recheck pressure if one of these
conditions has changed (e.g., significant weather
change, driving in the mountains).
1. Inflate tires to the specified air pressure. Refer
to the following table.
6 / 32
XPS BRAKES AND
and a clean
PARTS TO BE INSTALLED

Battery

NOTE:
it needs to be fully charged prior to vehicle deliv-
ery. To perform charging of the battery you will
need to removed battery from vehicle.
1. Battery location
1. Refer to the latest edition of
2. Open seat.
3. Remove LH and RH upper side panels.
1. Locking tie
2. Front panel screw
3. Panel nut
2011-1
COLD TIRE PRESSURE RECOMMENDATION
FRONT
103 kPa (15 PSI)
The battery is filled and serviced. However
rmo2008-001-029_d
STER BATTERIES SERVICE BULLETIN
proper activating, charging and maintenance
procedures.
3.1 Cut locking tie retaining front screw and
panel nut.
rbl2011-002-003_a
3.2 Remove rear panel screws.
REAR
193 kPa (28 PSI)
CAN-AM ROAD-
for
PREDELIVERY