Clutch Lever; Suspension - BRP Can-Am Spyder RS 2011 Series Predelivery Bulletin

ADJUSTMENTS
rmr2008-031-003
TYPICAL - SWING ARM ALIGNS WITH A SPOKE
7. Position the sensor behind the LH passenger
footrest and hold the sonic tension meter sen-
sor approximately 1 cm (1/2 in) from belt or
closer without touching the belt.
rbs2010-006-002
SPYDER GS/RS
8. Tap the belt to make the belt vibrate and note
the measurement.
9. Repeat step 8.
The second value should be within ±25N. If
NOTE:
not, repeat measurements until tolerance is met.
rmr2008-031-004_a
TYPICAL – SPYDER RS SHOWN
1. Tap the belt
2. Sonic tension meter sensor
10. Repeat steps 6 to 9 for the 2 remaining wheel
spokes.
The average of the 3 obtained values (at the 3
spokes) must be within the following range:
20 / 32
DRIVE BELT TENSION
(PARTS AT ROOM TEMPERATURE AND
REAR WHEEL LIFTED)
If the tension of drive belt is out of specification,
adjust drive belt as per
JUSTMENT . Refer to
in the proper CAN-AM ROADSTER SHOP MAN-
UAL
.

Clutch Lever

The distance between the clutch lever and
NOTE:
handgrip can be adjusted from position 1 (greatest
distance) to position 4 (smallest distance).
1. Adjust the clutch lever as per the owner's pref-
erence.
1.1 Push the clutch lever forward to release
the adjuster dial. Hold in position.
1.2 Turn the adjuster dial to the desired posi-
tion aligning the dial number with the dot
on the lever.
1.3 Release the clutch lever.
rmo2008-001-020_a
CLUTCH LEVER ADJUSTMENT
1. Clutch lever
2. Adjuster dial

Suspension

Left and right adjusting cams must always
be set at the same position. Never adjust
one adjusting cam only. Uneven adjustment
can cause poor handling and loss of stability,
which could lead to an accident.
2011-1
450N ± 150N
DRIVE BELT TENSION AD-
DRIVE SYSTEM subsection
WARNING
PREDELIVERY